top of page

Evaluation of the Use of Graphite Nanoplatelets in Heat Dissipation in Electronics

Athiyan Arulaazhi
21/11/26

Localised heat accumulation in the electronic devices leads to the processor's throttling and decreases the efficiency of the device, which is a significant challenge in the design of modern electronic packages, which need efficient heat dissipation. This study compares the thermal interface performance of a composite silicone thermal pad filled with graphite nanoplatelets (GNP) (1.0 mm nominal thickness, ~20 wt%, ~15 vol%) with a conventional silicone thermal pad filled with ceramic (1.0 mm nominal thickness, 60 wt%). Five sequential technical replicates (N=5) were tested under a continuous active heat flux of 10.0W/cm2 (12.0 W heat load) in a climate-controlled enclosure with an ambient temperature of Tambient=28.040.3˚C. The ASTM D5470 principles were followed, with the GNP pad having a mean peak operating temperature of 46.340.42˚C compared to 56.220.51˚C for the ceramic control pad, which is a mean thermal rise or thermal elevation reduction of 35.06% or 9.88˚C. The calculated thermal resistance (Rth) of the GNP pad was 1.520.04K/W (thermal impedance Zth=1.84 Kcm2/W), representing a 34.89% decrease relative to the control (2.350.04K/W; Zth=2.82 Kcm2/W). In addition, the GNP pad reached steady state thermal equilibrium (dT/dt<0.1˚C/min)in 10 minutes, which is 33.3% faster than the ceramic control pad (15 minutes). A two-tailed paired-samples t-test confirmed high statistical significance(t(4)=86.79, p<0.0001, Cohen's d=21.2, 95% CI for mean difference: [9.58˚C, 10.18˚C]). The results show a significant reduction in the interface thermal resistance of 2D carbon nanoplatelets when subjected to steady-state continuous loading, and this result serves as a benchmark to drive further multi-specimen screening and dielectric isolation tests.

bottom of page